C18

Standard Equipment

• AIR INLET SYSTEM
  • Separate circuit after-cooled (SCAC)
  • Open Crankcase Ventilation (OCV) system
  • Turbocharger, jacket water cooled
  • Turbocharger inlet, 152 mm (6 in) OD straight connection
• COOLING SYSTEM
  • Separate Circuit After-Cooling (SCAC) for both HEX and Keel cooled engines
  • Engine JW and SCAC Shell & Tube Heat Exchangers for HEX cooled engines
  • SCAC pump, gear driven, for HEX cooled engines only
  • Jacket water pump, gear driven
  • Sea water pump, bronze impeller, gear driven
  • SCAC and JW shunt tanks for maintaining proper pump inlet pressures
• EXHAUST SYSTEM
  • Water-cooled exhaust manifold & turbocharger
  • 152 mm (6 in) round flanged outlet
• FLYWHEELS & FLYWHEEL HOUSINGS
  • Flywheel Housing, SAE No. 0
  • Flywheel, 18 inch, 136 teeth
  • SAE standard rotation
  • SAE No. 1, Flywheel: 14 inch, 113 teeth
• FUEL SYSTEM
  • Front service simplex fuel system
  • Fuel transfer pump, gear driven
  • Manual fuel priming pump
  • Hybrid fuel line design
• LUBE SYSTEM
  • Front service simplex oil system
  • Center sump oil pan:
  • Front and top service oil filler locations
  • Front service dipstick
  • Oil pump, gear driven
• MOUNTING SYSTEM
  • Front support - adjustable
• POWER TAKE-OFFS
  • Poly-V groove for alternator drive
  • NOTE: There are no standard power take-offs available
• GENERAL
  • Front damper guard
  • Front service engine
  • Common electrical bonding point
  • Engine does not ship with zinc components
  • Engine is certified to D2/E2 emissions cycles
  • CERTIFIED TO EU STAGE IIIA AND CCNR STAGE II (E3 CYCLE) EMISSIONS STANDARDS.
• CONTROL SYSTEM
  • Programmable low idle
  • WOSR (Wide Operating Speed Range) available for EPA Tier 3 - B and C Ratings
  • Adjustable High Idle (TEL) - EPA Tier 3 WOSR Ratings Only
  • Electronic diagnostics and fault logging
  • Engine and transmission monitoring (speed, temperature, pressure)
  • Electronic fuel/air ratio contro
  • Engine Protection Mode for extended ambient conditions - EPA Tier 3 Ratings Only
  • Torque Limiting functionality for WOSR ratings only
  • 70-pin customer connector
  • Three types of throttle inputs (primary/ secondary PWM, 0-5V, 4-20mA +/-

Optional Equipment

• EXHAUST SYSTEM
  • Dry Elbows
  • Water-Cooled Elbows
  • Flexible Fitting
  • Flange
  • Muffler
  • Muffler Spark Arresting
• AIR INLET SYSTEM
  • Air Inlet Adapter
• CHARGING SYSTEM
  • Battery Chargers
  • Charging Alternators
  • Alternator Mounting Group
  • Ammeter
• CONTROL SYSTEM
  • MECP I
  • CATERPILLAR ALARM AND PROTECTION
• COOLING SYSTEM
  • AUX EXPANSION TANK FLANGE KIT
• FUEL SYSTEM
  • Duplex Fuel Filters
  • Flexible Fuel Lines
  • Fuel Cooler
  • Primary Fuel Filters
• INSTRUMENTATION
  • Instrument Panels
  • OEM Wiring Harness
  • Engine to Engine Harness
  • Gauges
  • Transmission Sensors
  • Oil Level Sensor
• LUBE SYSTEM
  • Duplex Oil Filters
  • Transmission Oil Cooler
  • Sump Pump
• MOUNTING SYSTEM
  • Vibration Isolators
  • Front Support
  • Rear Support
• POWER TAKE-OFFS
  • NOTE: PTO OPTIONS REQUIRE TORSIONAL VIBRATION ANALYSIS
  • Crankshaft Pulleys
  • Front Stub Shaft
  • Hydraulic Pump Drive Adapter
  • Front Enclosed Clutch
• PROTECTION SYSTEM
  • Marine Classification Society and SOLAS
  • Marine Classification Society and Fire Resistance
• STARTING SYSTEM
  • STARTING SYSTEM Electric Starting Motors - Single 24 Volt
  • Air Starting Motor
  • Air Start Accessories
  • Starting Aids - JW Heaters
  • Battery Sets - 24 Volt - Dry
• PACKING
  • Engine Protective Cover
  • Storage Preservation
  • Export Packing

Specs